- Extron Electronics Multi-Graphic Processor User's Manual
Table Of Contents
- Chapter One
- Introduction
- Chapter Two
- Installation
- Chapter Three
- Operation
- Front Panel Features
- Power-up and Default Cycle
- Window Select Buttons
- Input Selection
- Menus, Configuration, and Adjustments
- Picture Controls
- Auto Memories
- Memory Presets
- Additional Features
- Chapter Four
- Software Configuration and Control
- Chapter Five
- HTML Configuration and Control
- Accessing the Web Pages
- Viewing System Status
- Using the Configuration Page
- Using the File Management Page
- Using the Control Page
- Using the Background Page
- Chapter Six
- Special Applications
- Appendix A
- Specifications, Part Numbers, and Accessories
- Appendix B
- Firmware Update Guide
4-23
MGP 464 • Software Conguration and Control
PRELIMINARY
Command/response table for SIS commands (continued)
Command
ASCII (Telnet)
(host to processor)
Response
(processor to host)
Additional description
Film mode
Enable lm mode
18 *
X50)
* 1 #
X50)
Flm 1
]
Enable lm mode for input
X50)
. (Auto-senses for
3:2 or 2:2 pull-down.)
X50)
= 1 through 19.
Disable film mode
18 *
X50)
* 0 #
X50)
Flm 0
]
Disable film mode for input
X50)
. (Blocks the
deinterlacer from using either pull-down method.)
View lm mode status
18 *
X50)
# 0
]
(off) or 1
]
(on) View the current lm mode setting for input
X50)
.
Auto image
Run Auto image
55 *
X50@
# Img
X50@
]
Runs Auto image on window
X50@
.
X50@
= 1 through 4.