Installation Guide VSW I AAP Remote Input and Control Panel 68-1187-01 Rev.
Installation and Operation VSW I AAP Interface The VSW I AAP passive interface features a computer video input and pass-through, an unbalanced stereo input and pass-through, and an input select (Show Me) button. All VGA, audio, and control signals are carried from the rear panel of the AAP to the switcher via a single Extron VGA/audio cable assembly.
Rear panel features 1 2 Figure 2 — Rear panel features a Audio pass-through — Output unbalanced stereo audio through this 3.5 mm mini audio jack. See the previous section's wiring diagram (b). b Computer video pass-through — Output VGA-UXGA, RGBHV, RGBS, RGsB, RsGsBs, component video, or HDTV component video through this 15-pin female VGA connector. Interfacing to SW VGA Series Switchers The VSW I AAP can be connected to each input of a SW VGArs switcher.
Interfacing Interfacing to a VSW 2VGA A Daisy Chain VSW 2VGA A switchers can be daisy chained together to form a presentation system (figure 4). Each switcher connects to a VSW I AAP. By pressing the AAP's Show Me button, the user sends a control signal telling the switcher to select this AAP as the active input. Refer to the VSW 2VGA A Switchers manual for connection instructions.
Configuration Setting VSW I AAP Jumpers A jumper (figure 5) on the VSW I AAP may need to be shifted, from jumper J6 (the default position) to J5, depending on the switcher to which the VSW is connected. Refer to the applicable switcher’s manual to see how to determine the switcher’s board version or level.
www.extron.com Extron Electronics, USA 1230 South Lewis Street Anaheim, CA 92805 800.633.9876 714.491.1500 FAX 714.491.1517 Extron Electronics, Europe Beeldschermweg 6C 3821 AH Amersfoort, The Netherlands +800.3987.6673 +31.33.453.4040 FAX +31.33.453.4050 Extron Electronics, Asia 135 Joo Seng Rd. #04-01 PM Industrial Bldg., Singapore 368363 +800.7339.8766 +65.6383.4400 FAX +65.6383.4664 © 2007 Extron Electronics. All rights reserved.