User's Manual Part 2

The Extricom WLAN System User Guide 27
2. Configure the LAN parameters. Refer to Table 6 for a description of the LAN parameters.
Table 6. LAN Configuration Parameters
Field Description
IP Address Enter the main IP address of the Extricom Switch.
Network Mask Enter the network mask address.
VLAN Management VLAN tag ID for VLAN access to manage
the switch.
2
nd
IP Address Enter the backup IP address of the Extricom Switch.
2
nd
Network Mask Enter the backup network mask address.
2
nd
VLAN 2
nd
Management VLAN tag ID.
Default Gateway Enter the default gateway address.



The default gateway must be on the same
subnet as 1st or 2nd IP address.
Switch name A textual descriptor of the switch. Up to 32 characters.
Monitor On The Monitor Log is only relevant for a dedicated network
status monitoring tool that is not provided with the
switch. By default, this option should not be checked.



Check this option only if you are using the
Extricom dedicated network monitoring tool,
otherwise unnecessary data packets are sent
through the Ethernet.
Monitor Address Enter the address of the Monitor Log if using the
Extricom dedicated network monitoring tool.
Monitor Interval
(sec)
Specify how often information is sent to the Monitor
Log. If using the dedicated network status monitoring
tool, 1 second is the recommended interval.



Configure this parameter only if using the
dedicated network monitoring tool.
Syslog On Check the Syslog On option to record system information
in the System Log.



In most common operational scenarios, this
option should be unchecked (unless used for
troubleshooting).
Syslog Address Enter the IP address of the computer to which to send the
System Log.