User's Manual Part 1

The Extricom WLAN System User Guide 11
Figure 8 Extricom EXRP-40 AP
Plenum Rated External Antenna Access points



FCC Safety Compliance Statement
When used with approved Extricom antennas, this product meets the uncontrolled
environmental limits found in OET-65 . Proper installation of this radio according to
the instructions found in this manual will result in user exposure that is substantially
below the FCC recommended limits
Some applications may require an external antenna access point, for this purpose Extricom introduce a
new Access point based on the same Hardware as the EXRP-20/EXRP-40 but with external antennas.
Extricom defined the EXRP-xxE access point series, EXRP-20E , two radio access point with Four
external antenna connectors (parallel to EXRP-20) , the EXRP-40E Four radio access point with Eight
external antenna connectors (parallel to EXRP-40) .
Exactly as internal antennas APs , the external antenna APs are connected to the Extricom WLAN Switch
via standard Cat5e/6 cables. The APs are powered by the standard 802.3af Power over Ethernet (PoE), but
could also be powered up by an external power supply as defined by the internal antennas APs.
The External antenna connecter is RP (reverse polarity female –U.fi SMA), users can buy Rubber duck
4dbi 2.4/5Ghz dual band antennas with right connectors and connect it to the APs.