Instructions / Assembly

Tool Cart Assembly
Remove Drawers
Remove all drawers before
installing the posts.
a. Pull out the drawer so that
it is almost fully extended. Pull
up on the black release lever
on one side while pushing
down on the release lever on
the other side of the drawer.
b. While holding the levers
in the release positions, pull
the drawer out until it is fully
released from the drawer
slides.
c. LOCK TOOL CART LID!
Post Installation
a. MAKE SURE TOOL CART
LID IS LOCKED!
Place a soft mat or blanket on
the ground and carefully lay the
shell of the tool cart on its back.
Tool cart is heavy and may
require 2 adults to lay down.
b. Position the post over the
holes in the bottom corner of
the unit. Attach using M8 x 16
Phillips head screws with built-
in washer (Part #13). Repeat
procedure with remaining
posts.
c. Securely tighten all screws.