Instructions / Assembly

STEP 7 - Install the Lid
Install the Lid onto the body of the Hutch. LID IS HEAVY!
LID INSTALLATION REQUIRES ASSISTANCE FROM AN ADULT to LIFT
and MAY REQUIRE the USE of MECHANICAL EQUIPMENT to PROPERLY POSITION!
a. Lift the lid into position on top of the hutch body as shown below.
b. Insert the M5x35mm Screw into the round opening on the Side Panel. Push the screw into the threaded
insert. Then, use the Allen Wrench (supplied with the parts) to drive the Screw all the way into the lid.
c. Insert one plastic hole plug in each of the socket head screw openings.
d. Repeat above procedure on the other side of the lid.
e. Insert Plastic Hole Plugs into each hole where Screw was installed.
Push M5 Screw into the hole in the side panel
and use Allen wrench to tighten.
Plastic Hole Plug