Quick Reference Guide

Notice
Copyright © 2016 Extreme Networks, Inc. All Rights Reserved.
Legal Notices
Extreme Networks, Inc., on behalf of or through its wholly-owned subsidiary,
Enterasys Networks, Inc., reserves the right to make changes in
specifications and other information contained in this document and its
website without prior notice. The reader should in all cases consult
representatives of Extreme Networks to determine whether any such
changes have been made.
The hardware, firmware, software or any specifications described or referred
to in this document are subject to change without notice.
Trademarks
Extreme Networks and the Extreme Networks logo are trademarks or
registered trademarks of Extreme Networks, Inc. in the United States and/or
other countries.
All other names (including any product names) mentioned in this document
are the property of their respective owners and may be trademarks or
registered trademarks of their respective companies/owners.
For additional information on Extreme Networks trademarks, please see:
www.extremenetworks.com/company/legal/trademarks/
Warranty
Warranty information for X870 series switches is located online at:
www.extremenetworks.com/go/warranty
Regulatory and Compliance Information
Federal Communications Commission (FCC) Notice
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a class A digital device, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment uses, generates, and can radiate radio frequency energy and if
not installed in accordance with the operator’s manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause interference in which case the user will be
required to correct the interference at his own expense.
WARNING: Changes or modifications made to this device which are not
expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Industry Canada Notice
CAN ICES-3 (A)/NMB-3(A)
This digital apparatus does not exceed the class A limits for radio noise
emissions from digital apparatus set out in the Radio Interference
Regulations of the Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques de la class A
prescrites dans le Règlement sur le brouillage radioélectrique édicté par le
ministère des Communications du Canada.
Class A ITE Notice
WARNING: This is a Class A product. In a domestic environment this
product may cause radio interference in which case the user may be
required to take adequate measures.
Product Safety
This product complies with the following international safety standards:
• UL 60950-1 2nd edition, A2:2014
• CAN/CSA-C22.2 No.60950-1-07 2nd Ed. 2014-10
• IEC 60950-1:2005 2nd+A1:2009+A2:2013
• EN 60950-1:2006+A11+A1+A12+A2
• 2014/35/EU
• CNS 14336-1
Optical Module Compliance
Extreme Networks pluggable optical modules and direct-attach cables meet
the following regulatory requirements:
• UL and/or CSA registered component for North America
• Class 1 or Class 1M Laser Product
• FCC 21 CFR Chapter 1, Sub-chapter J in accordance with FDA & CDRH
requirements
• EN 60825-1:2007, EN 60825-2:2004+A1+A2 or later, European Standard
• Application of CE Mark in accordance with 2014/30/EU EMC Directive
and 2014/35/EU Low Voltage Directive
• 47 CFR Part 15, Class A when installed into Extreme products
Korea EMC Statement (KCC)
Australia (RCM)
This is a Class A product. In a domestic environment this product may cause
radio interference in which case the user may require to take adequate
measures.
Electromagnetic Compatibility (EMC)
This product complies with the following: FCC 47 CFR Part 15 Subpart B
Class A (US), ICES-003 (Canada), EN 55022 (ITE Emissions), EN 55024 (ITE
Immunity), EN 61000-3-2 (Harmonics), EN 61000-3-3 (Flicker), 2014/30/EU
(EMC Directive), EN 300 386 (Telecom), EN 50121-1 (Railroad), EN 55011
(ISM), EN 61000-6-2 (Ind. Immunity), EN 61000-6-4 (Ind. Emissions), RCM
(Australia), VCCI (Japan), MSIP KCC (Korea), BSMI (Taiwan), ANATEL
(Brazil), CCC (China).
VCCI Notice
This is a Class A product based on the standard of the Voluntary Control
Council for Interference by Information Technology Equipment (VCCI). If this
equipment is used in a domestic environment, radio disturbance may arise.
When such trouble occurs, the user may be required to take corrective
actions.
BSMI EMC Statement — Taiwan
This is a Class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.
Warning: The X870 switch may be hot to touch during normal
operation.
Attention: Le X870 peut être chaude au toucher pendant le
fonctionnement normal.
Warning: The X870 switch is designed for installation in restricted
access locations.
Attention: Le X870 est conçus pour une installation dans des
endroits à accès restreint.
Battery Warning — Taiwan
Hazardous Substances- EU
This product complies with the requirements of Directive 2011/65/EU of the
European Parliament and of the Council of 8 June 2011 on the restriction of
the use of certain hazardous substances in electrical and electronic
equipment.
European Waste Electrical and Electronic Equipment (WEEE)
Notice
In accordance with Directive 2012/19/EU of the European Parliament on
waste electrical and electronic equipment (WEEE):
1 The symbol above indicates that separate collection of electrical and
electronic equipment is required.
2 When this product has reached the end of its serviceable life, it cannot be
disposed of as unsorted municipal waste. It must be collected and treated
separately.
3 It has been determined by the European Parliament that there are
potential negative effects on the environment and human health as a
result of the presence of hazardous substances in electrical and electronic
equipment.
4 It is the users’ responsibility to utilize the available collection system to
ensure WEEE is properly treated.
For information about the available collection system, please contact
Extreme Customer Support at [phone] (Ireland).
Battery Notice
Warning: This product contains a battery used to maintain product
information. If the battery should need replacement it must be
replaced
by Service Personnel. Please contact Technical Support for
assistance.
Risk of explosion if battery is replaced by an incorrect type. Dispose
of expended battery in accordance with local disposal regulations.
Avertissements: Ce produit renferme une pile servant à conserver
les renseignements sur le produit. Le cas échéant, faites remplacer la
pile par le personnel du service de réparation. Veuillez communiquer
avec l’assistance technique pour du soutien.
Il y a risque d’explosion si la pile est remplacée par un type de pile
incorrect. Éliminez les piles usées en conformité aux règlements
locaux d'élimination des piles.
Extreme Networks
ExtremeSwitching
X870 Series Switches
Quick Reference
X870-32c
X870-96x-8c
P/N 121149-00
Hazardous Substances- China and Taiwan BSMI RoHS
Guidance concerning the China and Taiwan BSMI RoHS (Restriction of
Hazardous Substances) directive for this Extreme Networks® product can be
found on the following web page:
www.extremenetworks.com/support/documentation/restriction-hazardous-
substances/
The
page contains tables detailing the presence of 10 substances defined by
the RoHS directive.