Installation Guide

protocol, the switch can provide 30 Watts of power on a single port up to a total power budget of
60 Watts.
Note
Up to 90 watts of PoE power can be configured on the switch if it is used standalone and
not in a rack.
• Two unpopulated 1000BASE-X SFP ports (ports 9–10) that provide 2 Gbps of fiber connectivity.
Note
All the eight 10/100/1000BASE-T ports and all of the 1000BASE-X SFP ports can be used
simultaneously.
For information about SFPs, see the Extreme Networks Pluggable Interface Modules Installation
Guide.
• Ethernet management port.
• Serial console port implemented as an RJ45 connector, used to connect a terminal and perform local
management.
• LEDs to indicate port status and switch operating conditions
For a description of the LEDs and their operation, see Summit X430 Series Switch LEDs on page
55.
Note
If you are desktop mounting a Summit X430-8p switches you must use the four rubber
pads to maintain sucient airflow around the unit See Installing Summit Switches in
Desktop or Free-Standing Mode on page 327 for installation instructions.
Note
If you are rack mounting Summit X430-8p switches, you must use special "keep out" rack
mounting hardware. Rack mounting hardware must be ordered separately and you must
reserve at least 2 RU of space for the unit. For installation instructions, see Installing a
Summit X430-8p or X440-8t Switch in a Rack on page 316.
4
2
1
3
Figure 27: Summit X430-8p Switch Front Panel
1 = Ethernet management port
3 = SFP ports
Summit Switches Summit X430-8p Switch Ports and Slots
Summit Family Hardware Installation Guide 51