Installation Guide

Removing or Replacing a V300 Virtual Port Extender
For instructions on installing a V300 Virtual Port Extender, refer to Installing a V300 Virtual Port
Extender on page 412.
To replace a V300 Virtual Port Extender or remove it from service, follow these steps:
1. Disconnect the port extender from its power source and, if applicable, from its redundant power
supply.
2. Support the port extender while you remove the rack-mounting screws that hold the front mounting
brackets in place against the rack posts.
3. Carefully slide the port extender out of the rack.
4. Place the port extender on a secure,
flat surface.
Optionally, remove the mounting brackets from the sides.
5. Install a new port extender using the instructions in Installing a V300 Virtual Port Extender on page
412.
Removing or Replacing a V400 Virtual Port Extender
For instructions for installing a V400 Virtual Port Extender, refer to Installing a V400 Virtual Port
Extender on page 434.
To replace a V400 Virtual Port Extender or remove it from service, follow these steps:
1. Disconnect the port extender from its power source and, if applicable, from its redundant power
supply.
2. Support the port extender while you remove the rack-mounting screws that hold the front mounting
brackets in place against the rack posts.
3. Carefully slide the port extender out of the rack.
4. Place the port extender on a secure, flat surface.
Optionally, remove the mounting brackets from the sides.
5. Install a new port extender using the instructions in Installing a V400 Virtual Port Extender on page
434.
Removing or Replacing an LRM/MACsec Adapter
Refer to Installing an LRM/MACsec Adapter on page 434 for installation options for the LRM/MACsec
Adapter.
Note
The LRM/MACsec Adapter is hot-swappable.
To replace an LRM/MACsec Adapter or remove it from service, follow these steps:
1. If a USB cable is used to supply power to the adapter, unplug the USB cable from the front of the
adapter.
2. Disconnect network cables or transceivers from the Link1 and Link2 slots on the front of the adapter.
3. Disconnect the 50 cm SFP cables from the HostPort1 and HostPort2 slots on the front of the
adapter.
Removing and Replacing Expansion Modules
Removing or Replacing a V300 Virtual Port Extender
Summit Family Hardware Installation Guide 503