Installation Guide

Installing Expansion Modules
Installing a V300 Virtual Port Extender on page 412
Installing a V400 Virtual Port Extender on page 434
Installing an LRM/MACsec Adapter on page 434
Installing a Half-Duplex to Full-Duplex Converter on page 438
Installing a Summit Port Option Card on page 440
Installing an Option Card in Slot B of a Summit X460 Series Switch on page 443
Installing a Versatile Interface Module in a Summit X460, X480, X650, or X670
Series Switch on page 445
Installing a Versatile Interface Module or Clock Module in an X460-G2 Series
Switch on page 446
Install a Versatile Interface Module in a VSP 4900 Series Switch on page 447
Install an SSD Module on page 449
This chapter describes how to install expansion modules:
• The V300 Virtual Port Extender
• The V400 Virtual Port Extender
• The LRM/MACsec Adapter
• The Half-Duplex to Full-Duplex Converter
• Port option cards
• Versatile interface modules (VIM/VIM5s)
• Solid-state Drive (SSD) modules
Note
Read the information in this chapter thoroughly before trying install or remove an expansion
module.
To install port option cards, VIMs, and stacking modules that work with other Extreme Networks
switches, refer to ExtremeSwitching and Summit Switches: Hardware Installation Guide for Switches
Using ExtremeXOS 16 or Earlier.
Installing a V300 Virtual Port Extender
The following installation instructions are applicable to the V300-8P-2T-W (PoE) model. The
V300-8P-2X, V300-8T-2X, V300HT-8P-2X, and V300HT-8T-2X models will be referred to as non-PoE
models from this point on.
412
Summit Family Hardware Installation Guide