Installation Guide

Installing a Single VX-RPS-1000 Power Supply in a Rack
To install the VX-RPS-1000 power supply in a 19-inch rack, you need four customer-supplied screws to
attach the power supply to a standard 19-inch rack.
Caution
Observe all ESD precautions when handling sensitive electronic equipment.
Caution
Before rack-mounting the device, ensure that the rack can support it without compromising
stability. Otherwise, personal injury and/or equipment damage can result.
To install a single VX-RPS-1000 power supply in a rack, follow these steps.
1. Use screws (provided) to attach a long bracket to one side of the power supply.
Use the holes closest to the rear of the power supply.
2. Attach the other bracket to the other side of the power supply.
Figure 344: Long Brackets Attached to VX-RPS-1000 Power Supply
3. Align the holes at the end of each bracket with the rack post holes.
4. Secure the power supply to the rack with rack-mounting screws.
5. Connect a power cable (included with the power supply) to the output socket on the power supply
and the RPS input connector on the rear of the V400 unit.
6. Connect an AC power cord (not included) to the AC power input socket on the power supply and to
an AC power outlet.
When power is connected, verify that the power supply’s DC OK LED turns green. Verify that the
port extender’s PWR LED turns green.
Installing up to Three VX-RPS-1000 Power Supplies on a Shelf
You can install up to three VX-RPS-1000 power supplies in the 3-Slot Modular Shelf (Part no. 18201). The
shelf is mounted in a standard equipment rack.
Installing External Power Supplies
Installing a Single VX-RPS-1000 Power Supply in a Rack
Summit Family Hardware Installation Guide 409