Installation Guide

5. Connect an appropriate AC power cord to the AC connector on the EPS-600LS unit (see Figure 311
on page 380).
Use the cable clip on the EPS-600LS unit to hold the AC power cord in place (see Figure 311).
Caution
The EPS-600LS unit does not have a switch for turning the unit on and o. Disconnect
power to the EPS-600LS unit by removing the plug from the electrical outlet. Make sure
that this connection is easily accessible to you.
Note
An AC power cord is not provided with the EPS-600LS unit. See Power Cord
Requirements for AC-Powered Switches and AC Power Supplies on page 653 for
information about selecting a power cord.
Figure 311: Connecting the AC Power Cord
6. Connect the other end of the AC power cord to the electrical outlet (see the figure above).
Be sure that the electrical outlet is properly grounded.
7. Repeat the procedure for each additional EPS-600LS unit.
Installing an EPS-C2 Power Supply
Install one, two, or three Summit 750 W AC power supplies (model 10931) in the EPS-C2 chassis (model
10936) to build an external redundant power system for one or more compatible switches
One redundant power cable is shipped with the EPS-C2 chassis to provide the connection between the
external power system and the redundant power input connector on the back of a switch. Additional
redundant power cables are available from Extreme Networks.
Installing an EPS-C2 Power Supply
Installing External Power Supplies
380 Summit Family Hardware Installation Guide