Installation Guide

2. Slide the EPS-600LS into an empty slot in the EPS-C.
Caution
Be sure that empty slots in the EPS-C chassis are always covered by a cover plate when
not in use. The EPS-C is shipped with slots 2 and 3 covered and slot 1 open. Extreme
Networks recommends that you populate slot 1 with an EPS-600LS unit first, but this is
not required. You can install EPS-600LS units into any of the slots in the EPS-C. The
installation sequence does not aect the performance of the power supply units, but
empty slots must be covered at all times.
Figure 309: Installing the EPS-600LS Unit in the EPS-C Chassis
3. Slide the unit completely into the chassis until the front of the EPS-600LS is flush with the surface of
the EPS-C (see Figure 310).
Installing the EPS-600LS Power Supply
Installing External Power Supplies
378 Summit Family Hardware Installation Guide