Installation Guide

b. Insert the provided screws and tighten them securely.
Figure 307: Attaching the Mounting Bracket
c. Attach the mounting bracket for the other side of the EPS-C.
4. Slide the EPS-C into the rack and secure it using appropriate rack-mount screws.
5. Connect the keyed end of the redundant power cord to the EPS-C (see Figure 308). Verify that the
side of the connector marked TOP is facing up.
The key is a plastic tab on the cable connector housing that fits into the EPS-C to ensure correct
alignment of the connector.
6. Connect the other end of the redundant power cord to the Summit X450e-48p or X250e-48p
switch. Be sure that the side of the connector marked TOP is facing up (see Figure 308).
Figure 308: Installing the Redundant Power Cord
Installing the EPS-600LS Power Supply
To install an EPS-600LS unit into an EPS-C, follow these steps:
1. If necessary, remove a cover plate from a slot in the EPS-C.
Installing External Power Supplies
Installing the EPS-600LS Power Supply
Summit Family Hardware Installation Guide 377