Installation Guide

b. Insert the screws and fully tighten them using a screwdriver.
Figure 300: Attaching the Mounting Bracket
c. Attach the mounting bracket for the other side of the EPS-T.
4. Slide the EPS-T into the rack and secure it using appropriate rack-mount screws.
Installing the EPS-160 Power Supply into an EPS-T
To install an EPS-160 power supply into the EPS-T, follow these steps:
1. Remove the EPS-160 power supply from the packing material.
2. Remove the cover plate from an empty slot on the EPS-T.
3. Insert the power supply into the empty slot on the EPS-T.
4. Tighten the captive thumbscrews to secure the power supply to the EPS-T.
Connect the EPS-160 power supply to the Summit switch, following the instructions in Connecting the
EPS-160 Power Supply to the Switch on page 371.
Connecting the EPS-160 Power Supply to the Switch
One end of the EPS-160 redundant power cord has a keyed connector to ensure correct alignment of
the connector.
The key is a plastic tab on the cord connector housing that fits into the EPS-160 unit.
Installing External Power Supplies
Installing the EPS-160 Power Supply into an EPS-T
Summit Family Hardware Installation Guide 371