Installation Guide

Installing External Power Supplies
Safety Considerations for Installing Power Supplies on page 364
Pre-installation Requirements on page 365
Installing an EPS-150DC External Power Module (with EPS-T2) on page 365
Installing an EPS-160 External Power Module (with EPS-T) on page 370
Installing an EPS-500 External Power Supply Unit on page 373
Installing an EPS-600LS External Power Module on page 375
Installing an EPS-C2 Power Supply on page 380
Installing an EPS-LD External Power Supply on page 389
Installing an RPS-150XT Redundant Power Supply on page 392
Installing an RPS-500p Redundant Power Supply on page 396
Installing an STK-RPS-150PS Redundant Power Supply on page 399
Installing an STK-RPS-1005PS Redundant Power Supply on page 404
Installing a VX-RPS-1000 Redundant Power Supply on page 408
Read the information in the following sections thoroughly before you attempt to install or remove an
external power supply.
For information about installing external power supplies that work with other Extreme Networks
switches, refer to ExtremeSwitching and Summit Switches: Hardware Installation Guide for Switches
Using ExtremeXOS 16 or Earlier.
Safety Considerations for Installing Power Supplies
Only trained service personnel should perform service to Extreme Networks switches and their
components.
Trained service personnel have read all related installation manuals, have the technical training and
experience necessary to be aware of the hazards to which they are exposed in performing a task, and
are aware of measures to minimize the danger to themselves or other persons.
Warning
Extreme Networks AC power supplies do not have switches for turning the unit on and o. To
disconnect the power to an Extreme Networks AC power supply, remove the wall plug from
the electrical outlet. Make sure that this connection is easily accessible.
364 Summit Family Hardware Installation Guide