Installation Guide

For connections to the 10GBASE-T ports on the Summit X650-24t switch, see the following table for
cable types and distances.
Cable Type Maximum Distance
CAT5E 55 meters
CAT6 55 meters
CAT6A 100 meters
Note
Cables used for connection to the 10GBASE-T ports on the Summit X650-24t switch must
meet the minimum requirements of the IEEE 802.3an standard.
Working carefully, one port at a time, do the following:
1. Verify that you have identified the correct cable for the port.
2. Use an alcohol wipe or other appropriate cleaning agent to clean the cable connectors; make sure
they are free of dust, oil, and other contaminants.
3. If you are using optical fiber cable, align the transmit (Tx) and receive (Rx) connectors with the
correct corresponding connectors on the switch or the I/O module.
4. Press the cable connectors into their mating connectors on the switch or I/O module until the cable
connector is firmly seated.
5. Repeat the preceding steps for the remaining cables on this or other switches or I/O modules.
6. Dress and secure the cable bundle to provide appropriate strain relief and protection against bends
and kinks.
Performing Initial Management Tasks
When you set up a switch for the first time, you must connect to the console to access the switch and
log in to perform initial security configuration.
Check http://ezcloudx.com/supportedhardware to see what switch models can be managed with
ExtremeCloud. If your switch is entitled for management by ExtremeCloud, you can optionally use the
installation instructions at http://ezcloudx.com/quickstart.
Otherwise, to perform normal setup and configuration, follow the instructions in these topics:
• Connecting a Switch to the Management Console on page 360
• Logging in for the First Time on page 361
You can also:
•
Configuring the Switch's IP Address for the Management VLAN on page 362
•
Configuring ExtremeXOS on the Switch on page 363
Connecting a Switch to the Management Console
Connect each switch to a central console to enable direct local management of the switch.
Performing Initial Management Tasks
Installing Switches
360 Summit Family Hardware Installation Guide