Installation Guide

Table 54: Front Panel LEDs (continued)
Label or Type Color/State Meaning
MD Steady green The motion detector feature is enabled. This
LED stays lit if the motion detector feature
shuts down the other LEDs on the switch.
Blinking green (other switch
LEDs are also lit)
Motion has been detected. The green blinking
continues for a few seconds, and then the MD
LED lights steady green.
Blinking amber (other
switch LEDs are o)
Motion has been detected. The motion
detector feature turns on the other switch
LEDs. The amber blinking continues for a few
seconds, and then the MD LED lights steady
green.
O The motion detector feature is disabled.
Table 55: 2-digit Stack number Indicator
Label or Type Color/State Meaning
Left digit (1) Reserved for future use.
Right digit (1 – 8) Indicates the position of this switch in the SummitStack configuration.
Upper half blinking This switch is the stack master node.
Lower half blinking This switch is the stack backup node.
Lit steadily This switch is a standby node in the stack.
Ethernet Ports
1 – 48
Steady green Link OK
Blinking green Activity
O No link or port disabled.
Management Port Steady green Link OK
Blinking green Activity
Table 56: Back Panel
Label or Type Color/State Meaning
QSFP+ port LED (on
installed VIM3 module)
Steady green Link OK
Blinking green Activity
ExtremeSwitching X670-G2 Series Switches
The X670-G2 series switches have 48 or 72 front-panel Ethernet ports that can provide 10-gigabit
Ethernet connectivity using installable SFP+ optical modules. In addition, the X670-G2-48x-4q series
switches oer four QSFP+ ports.
The X670-G2 series switches include the following base models:
• ExtremeSwitching X670-G2-48x-4q Switch Ports and Slots on page 151
Summit Switches
ExtremeSwitching X670-G2 Series Switches
Summit Family Hardware Installation Guide 149