Installation Guide

Installing a Half-Duplex to Full-Duplex Converter
The following options are available for installing the Half-Duplex to Full-Duplex Converter:
1 On a shelf that is mounted in an equipment rack. (The shelf can accommodate up to three
converters.)
See Installing Half-Duplex to Full-Duplex Converters in a 3-Slot Modular Shelf on page 256.
2 On a flat surface.
See Mounting a Half-Duplex to Full-Duplex Converter on a Flat Surface on page 256.
3 On a wall.
See Mounting a Half-Duplex to Full-Duplex Converter on a Wall on page 257.
Installing Half-Duplex to Full-Duplex Converters in a 3-Slot Modular Shelf
Refer to Installing a Half-Duplex to Full-Duplex Converter on page 256 for installation options for the
Half-Duplex to Full-Duplex Converter.
Before installing the converter in the 3-slot modular shelf (part no. STK-RPS-1005CH3), mount the shelf
in the rack. Follow the steps in the 3-Slot Modular Shelf Quick Reference Guide.
To install up to three Half-Duplex to Full-Duplex Converter units in the 3-slot modular shelf, follow these
steps:
1 Attach the four rubber feet (included) to the bottom of the converter, one at each corner.
2 Set the converter on the shelf.
3 Connect the converter to its power adapter, following the instructions in Connecting a Half-Duplex
to Full-Duplex Converter to its Power Adapter on page 257.
4 Secure the converter to the shelf using cable ties (included with the shelf).
Pass the ties through the holes in the shelf and secure them firmly around the converter.
5 Connect the full-duplex ports (FD1 - FD4) to the switch.
6 Connect the half-duplex ports (HD1 - HD4) to your half-duplex devices.
7 Install one or two additional Half-Duplex to Full-Duplex Converter units in the shelf, as described in
steps 1 on page 256 through 4.
Mounting a Half-Duplex to Full-Duplex Converter on a Flat Surface
Refer to Installing a Half-Duplex to Full-Duplex Converter on page 256 for installation options for the
Half-Duplex to Full-Duplex Converter.
To install a Half-Duplex to Full-Duplex Converter unit on a flat surface, follow these steps:
1 Attach the four rubber feet (included) to the bottom of the converter, one at each corner.
2 Set the converter on a flat, stable surface.
3 Connect the converter to its power adapter, following the instructions in Connecting a Half-Duplex
to Full-Duplex Converter to its Power Adapter on page 257.
4 Connect the full-duplex ports (FD1 - FD4) to the switch.
Installing Expansion Modules
ExtremeSwitching and Summit Switches: Hardware Installation Guide 256