Installation Guide

Table 79: Available Stacking Cables for Extreme Networks Switches (continued)
Part
Number
Cable Type, Length Compatible Ports and Devices
10313 QSFP+ direct-attach passive copper
cable, 3 meters
21-Gbps stacking ports on X450-G2 switches, QSFP+ ports
on X670-G2-48x-4q switches, and QSFP+ ports on X770
switches
10313A QSFP+ direct-attach passive copper
cable, 3 meters, 26 AWG (for X770 to
X770 stacking)
21-Gbps stacking ports on X450-G2 switches, QSFP+ ports
on X670-G2-48x-4q switches, and QSFP+ ports on X770
switches
10315 QSFP+ direct-attach active optical
cable, 10 meters
QSFP+ ports on X670-G2-48x-4q switches
10317 QSFP+ direct-attach active optical
cable, 50 meters
QSFP+ ports on X670-G2-48x-4q switches
10318 QSFP+ direct-attach active optical
cable, 100 meters
10323 QSFP+ direct-attach passive copper
cable, 5 meters
21-Gbps stacking ports on X450-G2 switches
10336 QSFP+ active optical cable, 3 meters 40-Gbps ports on X670-G2 switches; 40-Gbps ports on
X770 switches; 40-Gbps VIM ports on X460-G2 switches
10337 QSFP+ active optical cable, 5 meters
10410 QSFP28 passive copper cable, 0.5
meters
100-Gbps ports on X590, X690, and X870 switches
10411 QSFP28 passive copper cable, 1 meter
10413 QSFP28 passive copper cable, 3 meters
10414 QSFP28 passive copper cable, 5 meters
10441 QSFP28 x 4SFP28 (4x25Gb) active
optical breakout cable, 5 meters
100-Gbps ports on X590, X690, and X870 switches (see
Alternative Configuration for Optics on X590, X690, X695,
and X870 Switches on page 167 for more information)
10442 QSFP28 x 4SFP28 (4x25Gb) active
optical breakout cable, 7 meters
10443 QSFP28 x 4SFP28 (4x25Gb) active
optical breakout cable, 10 meters
10444 QSFP28 x 4SFP28 (4x25Gb) active
optical breakout cable, 20 meters
Note
For the most recent information about available cables, contact your Extreme Networks sales
representative or refer to Extreme Hardware/Software Compatibility and Recommendation
Matrices.
Alternative Configuration for Optics on X590, X690, X695, and X870 Switches
To use certain fiber cables and optical transceivers for stacking on X590, X690, X695, and X870
switches, you must use the V400 alternative-configuration option on the configure
stacking-support command. This option sets the stacking ports to 100 Gb, enables pre-emphasis,
and enables error correction using IEEE 802.3bj Clause 91 RS-FEC.
Building Stacks
ExtremeSwitching and Summit Switches: Hardware Installation Guide 167