Installation guide

Introduction
Summit WM3600 Wireless LAN Controller Installation Guide6
CAUTION
Care is required. Disregarding a caution can result in data loss or equipment malfunction.
WARNING!
Indicates a condition or procedure that could result in personal injury or equipment damage.
Warnings
● Read all installation instructions and site survey reports, and verify correct
equipment installation before connecting the system to its power source.
● Remove jewelry and watches before installing this equipment.
● Install the equipment in a rack with adequate dimensions and weight allowances.
● Verify the rack is anchored and cannot tip over or break away from its mountings.
● Verify the unit is grounded before connecting it to the power source.
● Verify any device connected to this unit is properly wired and grounded.
● Connect all power cords to a properly wired and grounded electrical circuit.
● Verify the electrical circuits have appropriate overload protection.
● Attach only approved power cords to the device.
● Extreme Networks strongly recommends the use of an Uninterruptible Power
Supply (UPS) that supports the Summit WM3600 wireless LAN controller power
rating. Not using a UPS can result in data loss or equipment damage due to a power
surge or power failure.
● Verify that the power connector and socket are accessible at all times during the
operation of the equipment.
● Do not work with power circuits in dimly lit spaces.
● Do not install this equipment or work with its power circuits during thunderstorms
or other weather conditions that could cause a power surge.
● Verify there is adequate ventilation around the device, and ambient temperatures
meet equipment operation specifications.