Installation guide

Summit WM3600 Wireless LAN Controller Installation Guide 23
Summit WM3600 wireless LAN controller
Console Port Setup
To add the Summit WM3600 wireless LAN controller to the network and prepare it for
initial configuration:
1 Using the supplied console cable (pictured below), connect the Summit WM3600
wireless LAN controller serial port to an RS-232 (DB-9) serial port on a separate
computer (the “configuration computer”).
The pinout for the RJ-45 to DB9 cable is shown in the following table.
2 On the configuration computer, configure a terminal emulation application
(such as HyperTerminal) as follows:
RJ-45 1 2 3 4,5 6 7 8
DB9 8 6 2 5 3 4 7
Terminal Type VT-100
Port COM port
Terminal Settings 19200bps transfer rate
8 data bits
no parity
1 stop bit
no flow control
no hardware compression