Specifications

Upgrading the Summit WM Software to V5R3 release
Summit WM Maintenance Guide, Software Version 5.330
12 Upgrade the software by running upgrade <file name> command. Type Yes to the Do you wish
to continue? prompt. The controller reboots after the successful installation of the software
components contained in the tar file.
SWM.extreme.com# upgrade os AC-MV-gxs-V5R3-1.tar
13 Apply the V5 license by running the copy key command.
To apply the V5 license:
a Run the copy key <server> <user> <dir> <file> command on the CLI.
The following are the parameter definitions of the copy key <server> <user> <dir>
<license file> command:
■ <server> – Specifies the IP address of the server
■ <user> – Specifies the user name of an account on the server
■ <dir> – Specifies the name of a directory on the server
■ <license file> – Specifies the file name on the Summit WM Controller.
NOTE
If you are upgrading from V5R1 to V5R3 release, you do not have to apply the Summit WM Software V5 license.
Migrating the platform configuration
The following platform describes how to migrate the platform configuration from one platform, running
V4R1 GP7 (or higher GP) to another platform, running V5R3.
This section is applicable if you are migrating the configuration in the following scenarios:
Table 2: Configuration Migration table
From To
WM100 Controller WM100 Controller
WM100 Controller WM1000 Controller
WM100 Controller WM200/2000 Controller
WM1000 Controller WM100 Controller
WM1000 Controller WM1000 Controller
WM1000 Controller WM200/2000 Controller
WM200/2000 WM200/2000
WM20 WM20