Specifications

Upgrading the Summit WM Software to V5R3 release
Summit WM Maintenance Guide, Software Version 5.326
Upgrading the Summit WM Software via GUI
The following section is applicable if you are upgrading the Summit WM Software from any of the
following releases to V5R3 release via the Summit WM GUI.
● V4R1 GP7 to V5R3 release on Summit WM100/1000/200/2000 Controller
● V4R2 to V5R3 release on Summit WM20 Controller
● V5R1 to V5R3 on Summit WM100/1000/20/200/2000 Controller
NOTE
The Summit WM Controller, running the software versions less than V4R1 GP7, such as V1.1 GPx, V4R0.0.0.50,
and V4R0.0.1.14 must be first upgraded to V4R1 GP7 release before initiating the V5R3 upgrade. No license is
needed to perform this intermediary step. For more information, see “Upgrading from any past release less than
V4R1 GP7 release” on page 35
WM200/
2000
V4R1 GP7
(or higher GP)
“Upgrading the Summit WM
Software via GUI” on page 26
“Upgrading the Summit WM
Software via the CLI” on page 28
V5R1 “Upgrading the Summit WM
Software via GUI” on page 26
“Upgrading the Summit WM
Software via the CLI” on page 28
V5R3
(to V5R3 GPx)
“Upgrading the software from V5R3
to V5R3 GPx on the Summit WM20/
200/2000 Controller via the GUI” on
page 39
“Upgrading the Summit WM
Software via the CLI” on page 28
WM20 V4R2 “Upgrading the Summit WM
Software via GUI” on page 26
“Upgrading the Summit WM
Software via the CLI” on page 28
V5R1 “Upgrading the Summit WM
Software via GUI” on page 26
“Upgrading the Summit WM
Software via the CLI” on page 28
V5R3
(to V5R3 GPx)
“Upgrading the software from V5R3
to V5R3 GPx on the Summit WM20/
200/2000 Controller via the GUI” on
page 39
“Upgrading the Summit WM
Software via the CLI” on page 28
Configuration migration from one platform to another
Migrating the platform configuration from a platform running V4R1 GP7
to another one running V5R3
“Migrating the platform
configuration” on page 30
Upgrading the controllers operating in availability mode
Upgrading the two Controllers operating in ‘Availability’ mode “Upgrading the two Controllers
operating in ‘Availability’ mode” on
page 32
Table 1: Upgrade Matrix (Continued)
Platform From GUI CLI