Specifications

Summit WM Controller diagnostics
Summit WM Technical Reference Guide, Software Version 5.378
Summit WM Controller WM20 capacity
Table 23 shows the system capacities for the Summit WM20 Controller.
Summit WM Controller WM20 LEDs
The Summit WM Controller WM20 has four LEDs on its front panel.
Figure 8: Summit WM Controller WM20 LEDs
The description of the LED states is provided below:
● ACTIVITY LED – Indicates the CPU activity, including the amount of traffic carried to and from the
Wireless APs.
● STATUS LED – Indicates the normal state of the Summit WM Controller as seen by the system’s
software. This LED covers all stages of the Summit WM Controller, ranging from restarting, to
shutting-down. As long as the Summit WM Controller is running normally, this LED will remain lit.
● HDD Activity LED – Is hardware controlled to report Hard Drive Device (HDD) activity.
● Hot Swap Button LED – Indicates that the hot swap lever on the Summit WM Controller is pulled
out.
Table 23: Summit WM Controller WM20 capacity
Summit WM Controller WM20
Number of APs
32
Number of APs – Local and
Foreign (Availability)
64
Number of Users
512 + 512
Number of WM-AD
8
Number of Voicecalls
Minimum 61 (Simultaneous users/calls)
Maximum Throughput
200 Mbps over the two1000BT interfaces for mixed traffic Internet
distribution of packet sizes
Activity LED
Status LED
HDD Activity LED
Hot Swap LED