Manualshelf

Specifications

ManualsBrandsExtreme Networks ManualsComputer equipmentWM200
919293949596979899100
WM-AD configuration
Summit WM Getting Started Guide, Software Version 5.196
To configure a Bridge traffic locally at AP WM-AD:
1 From the main menu, click WM-AD Configuration. The WM-AD Configuration screen is displayed.
2 In the Add subnet text box, located in the lower portion of the left pane, type the WM-AD name.
3 Click Add subnet. The name is displayed in the virtual networks list and the To po lo gy tab is
displayed.
4 From the WM-AD Mode drop-down list, click Bridge Traffic Locally At AP. The VLAN Setting text
boxes are displayed.
5 To define the VLAN setting, select one of the following:
● Tagged – If you select Tag g ed , type the VLAN ID in VLAN ID text box. The default value is 1.
● Untagged – If you select Untagged, the VLAN will be untagged.
6 To save your changes, click Save.
You have created a WM-AD. Now you should configure the authentication mechanism for the WM-AD.
The following section explains how to configure the authentication mechanism.
Creating and configuring WDS WM-AD
For more information, see the Summit WM User Guide.
Assigning Wireless APs’ radios to WM-AD
Each radio of the Wireless AP can support up to eight WM-ADs (16 per Wireless AP).
The following is the list of Summit WM Controllers and the number of WM-ADs they can support.
● Summit WM2000 Controller: 64 WM-ADs
● Summit WM200 Controller: 32 WM-ADs
● Summit WM1000 Controller: 50 WM-ADs
● Summit WM100 Controller: 32 WM-ADs
● Summit WM20 Controller: 8 WM-ADs
To assign Wireless APs to a WM-AD:
1 From the main menu, click WM-AD Configuration. The WM-AD Configuration screen is displayed.
2 In the left pane WM_AD list, click the WM-AD you want to assign to the Wireless APs. The
Top o lo gy tab is displayed.
3 Click the RF tab.
4 In the SSID box, type the SSID that wireless devices will use to access the Wireless AP.
5 In the Advanced RF Settings, select the following:
● Suppress SSID – Select to prevent this SSID from appearing in the beacon message sent by the
Summit WM Controller. The wireless device user seeking network access will not see this SSID as
an available choice, and will need to specify it.