Specifications

Wireless AP configuration
Summit WM Getting Started Guide, Software Version 5.190
After the initialization and discovery is completed and the 802.11n AP is connected to the Summit WM
Controller, the LEDs L3 and L4 indicate the state of the corresponding radio — L3 for Radio 5 GHz, and
L4 for Radio 2.4 GHz.
The following table provides a view of the LEDs, L3 and L4, and the corresponding radio state after the
discovery is completed.
LED L2
The LED L2 indicates the status of the Ethernet port:
NOTE
10 Mb Ethernet connection is considered a warning state since it is not sufficient to sustain a single radio in the
legacy 11g or 11a modes.
Blink
Green
Off Blink Green Network discovery: 802.1x authentication
Blink Red Failed 802.1x authentication
Blink Green Blink Green Network discovery: DHCP
Blink Red Default IP address
Solid Green Blink Green Network discovery: WM discovery / connect
Blink Red Discovery failed
Solid
Green
Off Blink Green Connecting to WM: Registration
Blink Red Registration failed
Blink Green Blink Green Connecting to WM: Image upgrade
Blink Red Image upgrade failed
Solid Green Blink Green Connecting to HWX: Configuration
Blink Red Configuration failed
Blink Green Solid Green AO operating normally: Forced image upgrade
Blink Red Image upgrade failed
Table 14:
L3/L4 Radio status
Off Radio off
Solid Blue Radio in HT mode
Solid Green Radio in legacy mode
Table 15: LED L2 and Ethernet port’s status
L2 Ethernet port’s status
Off No Ethernet connection
Solid Blue 1 Gb Ethernet connection
Solid Green 100 Mb connection
Solid Orange 10 Mb connection
Table 13: LEDs, L3, L4 and L1, and Wireless AP’s detailed state (Continued)
L3 L4 L1 Altitude 802.11n AP’s detailed state