Specifications

Wireless AP configuration
Summit WM Getting Started Guide, Software Version 5.188
NOTE
After discovery is finished, left and right LEDs will be Green for ethernet uplink, and Yellow for WDS uplink.
NOTE
If the fatal AP error occurs, the Status LED will be solid Red.
Now you should configure the WM-AD via the Summit WM Controller using the Summit WM GUI.
The following chapter explains how to configure the WM-AD.
Altitude 802.11n AP LED status
The following figure shows the location of the LEDs on the Altitude 802.11n.
Figure 21: Altitude 802.11n AP LEDs
The LEDs, L1, L3 and L4 work in conjunction to indicate the general, high-level and detailed state
respectively.
Blinking
Green/Yellow
Blinking Red Connecting with WM: Image upgrade
Solid Red Image upgrade failed
Solid Green/
Yellow
Blinking Red Connecting with WM: Configuration
Solid Red Configuration failed
Blinking
Green/Yellow
Off AP operating and running normally: Forced image upgrade
Solid Red Image upgrade failed
Table 11: Outdoor AP LED status (Continued)
R1 LED R2 LED F LED Outdoor AP’s detailed status