Specifications

Summit WM Getting Started Guide, Software Version 5.1 87
Outdoor AP LED status
The following figure depicts the location of the LEDs on the Outdoor AP.
Figure 20: Outdoor AP LEDs
NOTE
Although Figure 5 depicts six LEDS, only R1, R2 and F LEDs are used in the current release. The remaining LEDs
are disabled.
The Center, Left and the Right LEDs work in conjunction to indicate the general, high-level state and
the detailed state respectively.
The following table provides a composite view of the three LED lights of the Outdoor AP’s state.
Table 11: Outdoor AP LED status
R1 LED R2 LED F LED Outdoor AP’s detailed status
Off Off Blinking Red Initialization: Power-on-self test (POST)
Blinking
Green
Blinking Red Initialization: Random delay
Solid Green Blinking Red Initialization: Vulnerable Period
Solid Red Reset to factory defaults
Solid Green Blink Red WDS scanning
Blinking
Green/
Yellow
Off Blinking Red Network discovery: 802.1x authentication
Solid Red Failed 802.1x authentication
Blinking
Green/Yellow
Blinking Red Network discovery: DHCP
Solid Red Default IP address
Solid Green/
Yellow
Blinking Red Network discovery: WM discovery/connect
Solid Red Discovery failed
Solid
Green
Off Blinking Red Connecting with WM: Registration
Solid Red Registration failed