Specifications

Wireless AP configuration
Summit WM Getting Started Guide, Software Version 5.186
NOTE
The Left and Right LEDs turn on after the center LED. This allows you to distinguish easily between the center LED
and the Left/Right LEDs.
NOTE
If the Center LED begins blinking RED, it indicates that the Wireless AP’s state has failed.
NOTE
Random delays do not occur during normal reboot. A random delay only occurs after vulnerable period power-down.
The Wireless AP can be reset to its factory default settings. For more information, see “Resetting the Wireless AP to
its factory default settings” on page 81.
Blinking
Green
Off Blinking
Green /
Orange
Network discovery: 802.1x authentication
Blinking Red Failed 802.1x authentication
Blinking Green Blinking
Green /
Orange
Network discovery: DHCP
Blinking Red Default IP address
Solid Green Blinking
Green /
Orange
Network discovery: WM discovery / connect
Blinking Red Discovery failed
Solid Green Off Blinking
Green /
Orange
Connecting with Summit WM Controller: Registration
Blinking Red Registration failed
Blinking Green Blinking
Green /
Orange
Connecting with Summit WM Controller: Image upgrade
Blinking Red Image upgrade failed
Solid Green Blinking
Green /
Orange
Connecting with Summit WM Controller: Configuration
Blinking Red Configuration failed
Blinking Green Solid Green /
Orange
AP operating normally: Forced image upgrade
Blinking Red Image upgrade failed
Table 10: Composite view of three LED lights (Continued)
Left LED Right LED Centre LED Altitude AP’s Detailed state