Specifications

Wireless AP configuration
Summit WM Getting Started Guide, Software Version 5.184
Altitude AP LED status
The following figure depicts the location of the three LEDs on the Altitude AP.
Figure 19: Altitude AP LEDs
WARNING!
Never disconnect a Wireless AP from its power supply during a firmware upgrade.
Disconnecting a Wireless AP from its power supply during a firmware upgrade may cause firmware corruption
rendering the AP unusable.
LEDs color codes
The AP LEDs indicate “normal-operation”, “warning/special”, or “failed” state of the Wireless AP in
the following color codes:
● Green – Indicates the normal-operation state.
● Orange/Amber – Indicates the warning, or special state such as WDS.
● Red – Indicates the error state.
● Blinking – Indicates that the state, such as initialization, or discovery is in progress.
● Steady – Indicates that the state is stable/completed. For example, initialization finished, or
discovery completed.
Center LED
The Center LED indicates the general status of the Wireless AP:
Table 7: Center LED and Wireless AP’s status
Center LED Altitude AP’s status
Blinking Green Initialization and discovery in progress via Ethernet link
Blinking Orange/Amber Initialization and discovery in progress via WDS link
Blinking Red Error during initialization/discovery process
Solid Red Irrecoverable error
Solid Green Discovery finished via Ethernet link
Solid Orange/Amber Discovery finished via WDS link
Left
LED
Status
LED
Right
LED