Specifications

Summit WM Getting Started Guide, Software Version 5.1 83
The following figure illustrates the location of the reset button on the Outdoor AP.
Figure 17: Position of the reset button with the housing cover removed
CAUTION
The reset button is located below the housing cover beside the sockets for the external antennas. To access the reset
button, you must remove the housing cover. For more information, see the Outdoor AP Installation Guide.
Resetting the Altitude 802.11n AP to its factory default settings
You can set the Altitude 802.11n AP to its factory default settings by pressing and holding the reset
button for approximately four seconds.
Figure 18: Position of the reset button on the Altitude 802.11n AP
NOTE
If you press the reset button and do not hold it over four seconds, the Altitude 802.11n AP will merely reboot and
not reset to its factory defaults.
Wireless AP’s LED states
When the Wireless AP is powered on and boots, you can follow its progress through the registration
process by observing the LED sequence as described in the following sections.
Reset Button