Specifications

Wireless AP configuration
Summit WM Getting Started Guide, Software Version 5.174
4 In the Discovery Timers section, type the discovery timer values in the following text boxes:
● Number of retries – Limited to 255 in a five minute discovery period. The default value is 3.
● Default between retries – The default value is 1 second.
5 To save your changes, click Save.
6 To initiate the discovery and registration process, connect the Wireless AP to a power source.
The Wireless APs can be connected and powered in several ways. For more information, see the
following section.
Powering the Wireless APs
Altitude AP
The Altitude AP can be connected, and powered in the following ways:
● Power over Ethernet (802.3af):
● PoE enabled switch port
● PoE Injector
● Power by AC adaptor
Outdoor AP
The Outdoor AP can be connected, and powered in the following ways:
● Power over Ethernet
● PoE enabled switch port
● PoE Injector
● Power by 48 V direct voltage
● 110-230 V DC direct voltage
For more information, see the Outdoor AP Installation Guide.
Altitude 802.11n AP
The Altitude 802.11n can be connected, and powered in the following ways:
● Power over Ethernet
● PoE enabled switch port
● PoE Injector
● Power by 48 V direct voltage
Manually approving pending Wireless APs
If the Summit WM Controller does not recognize the Wireless AP, the Wireless AP’s registration record
is created in pending state. You must manually approve a pending Wireless AP. As long as the Wireless