Specifications

Summit WM Getting Started Guide, Software Version 5.1 61
Configuring Summit WM Controller as IAS client
To configure Summit WM Controller as IAS client:
1 Click Start, point to Administrative Tool, and then click Internet Authentication Service.
2 Right-click Clients, and then New Client.
3 In the Friendly name text box, type the name that you want to assign to the Summit WM Controller,
and then click Next.
4 In the Client address (IP or DNS) text box, type the IP address of the Summit WM Controller, and
then click Verify.
5 Click Resolve. If the IP address is correct, it appears in the Search results text box.
6 Click Use this IP.
7 In the Client-Vendor list, click RADIUS Standard.
8 In the Shared secret text box, type a password that both the IAS server and the Summit WM
Controller will use to mutually authenticate.
NOTE
This password is case-sensitive. You can use alphanumeric characters. You must configure the same shared
secret password for WM-AD Global Settings. For more information, see Section 6.8 WM-AD Global Settings of
Summit WM User Guide.
9 Retype the password in the Confirm shared secret box, and then click Finish.
Configuring Remote Access Policies
To configure Remote Access Policy:
1 Click Start, point to Administrative Tool, and then click Internet Authentication Service.
2 Click Remote Access Policies.
3 In the right pane of the Internet Authentication Service, click Allow access if dial-in permission is
enabled, and then right-click Allow access if dial-in permission is enabled.
4 Click Delete. A dialogue box is displayed.
5 Click Yes on the dialogue box.