Specifications

Physical ports configuration
Summit WM Getting Started Guide, Software Version 5.144
Configuring physical data ports
To configure the data port interfaces on the Summit WM Controller:
1 From the main menu, click Summit Controller. The Summit Controller screen is displayed.
2 In the left pane, click IP Addresses. The Management Port Settings screen is displayed.
The lower part of the screen displays the four ethernet ports, and each MAC address is displayed
under the MAC column.
NOTE
The number of ports displayed on the Management Port Settings screen (on the GUI) reflects the number of
physical ports the Summit WM Controller has. For example, Summit WM100/200/2000 Controllers have four
data ports, and hence the Management Port Settings screen will display four ports. The Summit WM1000
Controller has two data ports. Therefore the Management Port Settings screen will display two ports.
The lowest part of the screen displays the text boxes for IP address, MAC address, Subnet mask and
MTU. You can edit these values.
3 To enable the port, select the checkbox under the Enable column.
NOTE
You must disable all the interfaces that are not in use in order to avoid routing loops.