Specifications

Summit WM Getting Started Guide, Software Version 5.1 27
Summit WM1000 Controller LEDs
The Summit WM1000 Controller has three LED lights on its back panel.
Figure 13: Summit WM1000 Controller LED Lights
The description of the LED states is provided below:
● LINK-UP LED – Displays the link status of management port Ethernet link as seen by the system’s
software. This LED is located only on the back panel of the Summit WM1000 Controller.
● STATUS LED – Indicates the normal state of the Summit WM Controller as seen by the system’s
software. This LED covers all stages of the Summit WM Controller, ranging from restarting, to
shutting-down. As long as the Summit WM Controller is running normally, this LED will remain lit.
The STATUS LED is located on the back panel as well as the front panel.
● ACTIVITY LED – Indicates the amount of traffic carried to and from the Wireless APs. The
ACTIVITY LED is located on the back panel as well as the front panel.
Summit WM100 Controller front panel
The Summit WM100 Controller does not have any component on the front panel except two LED lights.
The description of the LED states is provided below:
● STATUS LED– For more information, see the STATUS LED description in “Summit WM1000
Controller back panel” on page 26.
● ACTIVITY LED – For more information, see the ACTIVITY LED description in “Summit WM1000
Controller back panel” on page 26.
NOTE
The STATUS LED is located on the back panel as well as the front panel of the Summit WM100 Controller.
Link-up LED
Status LED Activity LED