Specifications

Summit WM Getting Started Guide, Software Version 5.1 121
8 In the Add text box, type the IP address of the Summit WM Controller mobility agent. The IP
address is displayed in the Permission List box.
You can add as many agents you want by repeating Step 8.
9 In the Permission List box, select the IP addresses you want to approve.
10 Click Approve. The IP addresses are approved.
11 In the Security Mode section, select either of the two options:
● Allow all mobility agents to connect – A new agent automatically registers itself with the
mobility manager and becomes part of the mobility domain.
● Allow only approved mobility agents to connect – The manager does not allow a new agent to
automatically register. Instead, the connection with the new agent is placed in pending state until
the administrator approves it.
12 To save your changes, click Save.
Configuring a Summit WM Controller as a mobility agent
To configure Summit WM Controller as a mobility agent:
1 From the main menu, click Summit Controller. The Summit Controller screen is displayed.
2 In the left pane, click Mobility Manager. The Mobility Manager Settings screen is displayed.
3 To enable mobility for this Summit WM Controller, select Enable Mobility. The mobility options are
displayed.
4 Select This Summit Controller is a Mobility Agent. The mobility agent options are displayed.
5 In the Port drop-down list, select the interface of the Summit WM Controller that is to be used as the
mobility agent.
Ensure that the selected interface is routable on the network.
6 In the Heartbeat text box, type the time interval (in seconds) for which the mobility agent should
wait for the connection establishment response before trying again. The default is 60.
7 In the Discovery Method drop-down list, select one of the following:
● SLPD (Service Location Protocol Daemon) – Enables the discovery of mobility manager Summit
WM Controller, using SLP. The mobility manager's address must be configured on the network
using SLP when selecting this option.
● Static Configuration – allows the mobility agent to discover the mobility manager without the
SLP support.
■ If you select Static Configuration, the Mobility Manager Address text box is displayed.
■ In the Mobility Manager Address text box, type the IP address of the Summit WM Controller
that will serve as the mobility manager.
8 To save your changes, click Save.
Viewing the Mobility Manager display
If you have configured a Summit WM Controller as a mobility manager, two additional displays appear
on the Reports & Displays screen:
● Client Location in Mobility Zone
● Mobility Tunnel Matrix