Specifications

WM-AD configuration
Summit WM Getting Started Guide, Software Version 5.1104
Configuring filtering rules for Exception filter
To configure rules for the Exception filter:
1 From the main menu, click WM-AD Configuration. The WM-AD Configuration screen is displayed.
2 In the left pane, click the SSID WM-AD for which you want to define the filtering rules. The
Top o lo gy tab is displayed.
3 Click the Filtering tab.
4 From the Filter ID drop-down list, click Exception.
5 Define a filtering rule.
a In the IP/subnet:port text box, type the destination IP address.
You can also specify the IP range, a port designation or a port range on the IP address in the IP/
subnet:port text box.
b From the Protocol drop-down list, click the applicable protocol.
The default is N/A.
c Click Add. The filtering rule is displayed.
6 Define a rule to allow access to the default gateway for this WM-AD.
a Select the IP:Port of the filtering rule that you defined in Step 5.
b In the IP/subnet:port, type the default gateway IP address (WM-AD’s IP address) that you
defined in the Topology tab for this WM-AD.
c Click Add. The rule is displayed.
7 Define more rules by carrying out Step 5 and Step 6.
8 Check the Allow feature for every rule you created.
You may edit the order of the rules by selecting a filter and clicking the Up/Down buttons. The
filtering rules are executed in the order that is displayed on the screen.
9 To save your changes, click Save. The rules for the Exception filter are saved.
Configuring filtering rules for a Non-authenticated filter
The rules for a Non-authenticated filter enable you to identify and manage the destinations to which a
mobile device is allowed to gain access without undergoing an authentication redirection. Typically, the
recommended default rule is to deny all. Administrators must define the rules that will permit users to
access essential services such as the following:
● DNS
● Default Gateway (WM-AD interface IP)
Any HTTP streams requested by the client for denied targets will be redirected to the specified location.
For more information, see the Summit WM User Guide.
To configure rules for the Non-authenticated filter.
1 From the main menu, click WM-AD Configuration. The WM-AD Configuration screen is displayed.
2 In the left pane, select the SSID WM-AD for which you want to configure the Non-authenticated
filtering rules. The Topology tab is displayed.
3 Click the Filtering tab.