User guide

Modifying Wireless AP Settings
Summit WM20 User Guide, Software Release 4.2 65
2 In the left pane, click Access Approval. The Access Approval screen is displayed, along with the
registered Wireless APs and their status.
3 To select the Wireless APs for status change, do one of the following:
● For a specific Wireless AP, select the corresponding checkbox.
● For Wireless APs by category, click one of the Select Altitude APs options.
To deselect your Wireless AP selections, click Clear All.
4 Click the appropriate Perform action on selected Altitude APs option:
● Approved – Change a Wireless AP's status from Pending to Approved, if the AP Registration
screen was set to register only approved Wireless APs.
● Pending – AP is removed from the Active list, and is forced into discovery.
● Release – Release foreign Wireless APs after recovery from a failover. Releasing an AP
corresponds to the Availability functionality. For more information, see Chapter 6, “Availability
and Controller Functionality.”
● Delete – Delete this Wireless AP from the WM-AD.
Configuring the Default AP Settings
Wireless APs are added with default settings. You can modify the system’s Wireless AP default settings
accordingly, and then use these default settings to configure newly added Wireless APs. In addition,
you can base the system’s Wireless AP default settings on an existing Wireless AP configuration or have
configured Wireless APs inherit the properties of the default Wireless AP configuration when they
register with the system.