User guide

Summit WM20 Controller
Summit WM20 User Guide, Software Release 4.2238
Summit WM20 Controller Panels
Figure 5: Summit WM20 Controller Panels
Console Port for Summit WM20 Controller
Summit WM20 uses the USB Control port as the console port for command line interface and to
perform diagnostics or a rescue procedure. It is used as a Serial over USB port. You need a USB male
A/B cable (not included) to connect your host (for example, a PC) to the console port. You also need to
install the virtual serial driver on your host PC. Before you connect your host to the USB port, you need
to download the appropriate driver and install it on your host machine. The link to download the
virtual serial driver is the following:
http://www.silabs.com/tgwWebApp/public/web_content/products/Microcontrollers/USB/en/mcu_vcp.htm
Table 20: Summit WM20 Controller Panel Legend
Legend Item Description
1 Power Switch Power socket on the rear panel
2 Management Port (eth0) Used to access WM20 Management via the GUI interface.
IP address = 192.168.10.1
3 Data Ports (esa0, esa1) Interface to wired network.
4 USB Control Port Used as the console port for command line interface and to perform
diagnostics or a rescue procedure. See details below.
5 USB Server Port For future use
6 Reset Button Soft reset of the Summit WM20 Controller
7 LEDs A column of 4 LEDs to indicate status of the Summit WM20 Controller,
See details below.