User guide

WM Access Domain Services Configuration
Summit WM20 User Guide, Software Release 4.2126
4 From the Filter ID drop-down list, select Non-Authenticated.
The Filtering tab automatically provides a Deny All rule already in place. Use this rule as the final
rule in the non-authenticated filter for Captive Portal.
5 For each filtering rule you are defining, do the following:
● In the IP/subnet:port box, type the destination IP address. You can also specify an IP range, a
port designation, or a port range on that IP address.
● In the Protocol drop-down list, select the applicable protocol. The default is N/A.
6 For Captive Portal assignment, define a rule to allow access to the default gateway for this WM-AD:
● Select IP/Port.
● Type the default gateway IP address that you defined in the Topology tab for this WM-AD.
7 Click Add. The information is displayed in the Filter Rules section of the tab.
8 Select the new filter, then do the following:
● If applicable, select In to refer to traffic from the wireless device that is trying to get on the
network.
● If applicable, select Out to refer to traffic from the network host that is trying to get to a wireless
device.
● Select the Allow checkbox applicable to the rule you defined.
9 Edit the order of a filter by selecting the filter and clicking the Up and Down buttons. The filtering
rules are executed in the order you define here.
10 To save your changes, click Save.