Specifications

Summit WM20 Controller
Summit WM20 Technical Reference Guide, Software Version 4.2 67
3 Under System Shutdown, select Halt System, and then click Apply Now. The following dialogue
box is displayed.
4 Click OK. The software’s operations is halted and you are logged out of the system.
NOTE
You can also use the CLI command to stop the software operation instead of Summit WM Graphical User
Interface (GUI).
5 Switch off the Summit WM20 controller’s power switch, located on the front panel. The power
receptacle is on the rear panel.
WARNING!
Do not power off the controller by directly using the power switches. Instead, carry out the aforesaid sequential
steps. Failure to do so may corrupt the data on the hard disk drive.