Quick Reference Guide

ExtremeWireless
TM
WiNG
TM
Access Point
Quick Reference
AP-7532-67040-US
AP-7532-67040-1-WR
AP-7532-67030-US
AP-7532-67030-1-WR
Notice
Copyright © 2018 Extreme Networks, Inc. All Rights Reserved.
Legal Notices
Extreme Networks, Inc. reserves the right to make changes in specifications and
other information contained in this document and its website without prior notice.
The reader should in all cases consult representatives of Extreme Networks to
determine whether any such changes have been made.
The hardware, firmware, software or any specifications described or referred to in
this document are subject to change without notice.
Trademarks
Extreme Networks and the Extreme Networks logo are trademarks or registered
trademarks of Extreme Networks, Inc. in the United States and/or other countries.
All other names (including any product names) mentioned in this document are
the property of their respective owners and may be trademarks or registered
trademarks of their respective companies/owners.
For additional information on Extreme Networks trademarks, please see:
www.extremenetworks.com/company/legal/trademarks/
Documentation & Support
For product support, including documentation, visit: www.extremenetworks.com/
Power Supply
This device must be powered from a 802.3af or 802.3at compliant power
source which has been certified by the appropriate agencies, or by a
approved UL LISTED ITE (IEC/EN 60950-1, LPS/SELV) power supply with
electrical ratings: Output 12 Vdc, min 1.25 A or 48 Vdc min 0.375 A (POE),
with a recommended ambient temperature greater than 40 degrees C. Use
of alternative power supply will invalidate any approvals given to this unit
and may be dangerous.
Federal Communications Commission (FCC) Notice:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Radio Transmitters (Part 15)
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Radio Frequency Interference Requirements - Canada
CAC ICES-3 (B)/NMB-3(B) Radio Transmitters
For RLAN Devices: The use of 5 GHz RLAN’s, for use in Canada, have the
following restrictions:
• Restricted Band 5.60 – 5.65 GHz
This device complies with RSS 247 of Industry Canada. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Label Marking: The Term "IC:" before the radio certification only signifies
that Industry Canada technical specifications were met.
In accordance with the regulations of Industry Canada, this radio transmitter
can operate with an antenna of a type and a maximum gain (or lower)
approved for the transmitter by Industry Canada. With the aim of reducing
the risk of radio interference to other users, the chosen antenna type and its
gain should be selected so that the equivalent isotropically radiated power
(e.i.r.p.) does not exceed the intensity necessary for the establishment of a
satisfactory connection.
Conformément à la réglementation d'Industrie Canada, le présent émetteur
radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou
inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de
réduire les risques de brouillage radioélectriqueà l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la
puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité
nécessaire àl'établissement d'une communication satisfaisante.
In compliance with respective local regulatory law, the AP software provides
professional installers the option to configure the antenna type and antenna
gain for approved antennas.
This radio transmitter (AP-7532, AP-7532I) has been approved by Industry
Canada to operate with the antenna types listed below and having a
maximum gain allowable and the impedance required for each type of
antenna. The antenna types not included in this list, or whose gain is higher
than the maximum gain indicates, are strictly prohibited for the operation of
the transmitter.
Le présent émetteur radio (AP-7532, AP-7532I) a été approuvé par Industrie
Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et
ayant un gain admissible maximal et l'impédance requise pour chaque type
d'antenne. Les types d'antenne non inclus dans cette liste ou dont le gain est
supérieur au gain maximal indiqué, sont strictement interdits pour
l'exploitation de l'émetteur.
CE Marking and European Economic Area (EEA)
This is a Class B product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.
The use of 2.4GHz RLAN’s, for use through the EEA, have the following
restrictions:
• Maximum radiated transmit power of 100 mW EIRP in the frequency
range 2.400 -2.4835 GHz.
Statement of Compliance
Extreme Networks hereby declares that this radio equipment is in
compliance with Directive 2011/65/EU and 1999/5/EC or 2014/53/EU (2014/
53/EU supersedes 1999/5/EC from 13thJune 2017).
Japan (VCCI) - Voluntary Control Council for
Interference
Korea Warning Statement for Class B ITE
Other Countries
Australia
Use of 5GHz RLAN’s in Australia is restricted in the following band 5.50 –
5.65GHz.
Brazil
Declarações Regulamentares para AP-7532/AP-7532I - Brasil
Nota: A marca de certificação se aplica ao Transceptor, modelo AP-7532.
Este equipamento opera em caráter secundário, isto é, não tem direito a
proteção contra interferência prejudicial, mesmo de estações do mesmo
tipo, e não pode causar interferência a sistemas operando em caráter
primário. Para maiores informações sobre ANATEL consulte o site:
www.anatel.gov.br
Este equipamento opera em caráter secundário, isto é, não tem direito a
proteção contra interferência prejudicial, mesmo de estações do mesmo
tipo, e não pode causar interferência a sistemas operando em caráter
primário.
Este produto está homologado pela Anatel, de acordo com os
procedimentos regulamentados pela Resolução n°242/2000 e atende aos
requisitos técnicos aplicados, incluindo os limites de exposição da Taxa de
Absorção Específica referente a campos elétricos, magnéticos e
eletromagnéticos de radiofrequência, de acordo com as Resoluções n° 303/
2002 e 533/2009.
Este dispositivo está em conformidade com as diretrizes de exposição à
radiofrequência quando posicionado pelo menos 25 centímetros de
distância do corpo. Para maiores informações, consulte o site da Anatel.
Chile
Este equipo cumple con la Resolución No 403 de 2008, de la Subsecretaria
de telecomunicaciones, relativa a radiaciones electromagnéticas.
China
Mexico
Restrict Frequency Range to: 2.450 – 2.4835 GHz.
S. Korea
Taiwan
「本器材須經專業工程人員安裝及設定，始得設置
使用，且不得直接販售給一般消費者」。
For AP-7532
For AP-7532I
Thailand
European Waste Electrical and Electronic
Equipment (WEEE) Notice
In accordance with Directive 2012/19/EU of the European Parliament on
waste electrical and electronic equipment (WEEE):
1 The symbol above indicates that separate collection of electrical and
electronic equipment is required.
2 When this product has reached the end of its serviceable life, it cannot be
disposed of as unsorted municipal waste. It must be collected and treated
separately.
3 It has been determined by the European Parliament that there are
potential negative effects on the environment and human health as a
result of the presence of hazardous substances in electrical and electronic
equipment.
4 It is the users’ responsibility to utilize the available collection system to
ensure WEEE is properly treated.
For information about the available collection system, please contact
Extreme Customer Support at 353 61 705500 (Ireland).
TURKISH WEEE Statement of Compliance
EEE Yönetmeliğine Uygundur
Access Point China ROHS Compliance
P/N 9035176-04