Managing Faults on Virtual Services Platform 7200 Series and 8000 Series Version 5

Variable Value
sender-ip <A.B.C.D> <A.B.C.D> Configures the SNMP trap receiver and source IP addresses.
Specify the IP address of the destination SNMP server that
receives the SNMP trap notification in the first IP address.
Specify the source IP address of the SNMP trap notification
packet that is transmitted in the second IP address. If this
address is 0.0.0.0, the system uses the IP address of the local
interface that is closest (from an IP routing table perspective) to
the destination SNMP server.
Enabling SNMP trap logging
Use SNMP trap logging to send a copy of all traps to the syslog server.
Before you begin
• You must configure and enable the syslog server.
About this task
Note:
The platform logs CLILOG and SNMPLOG as INFO. Normally, if you configure the logging level
to WARNING, the system skips all INFO messages. However, if you enable CLILOG and
SNMPLOG the system logs ACLI Log and SNMP Log information regardless of the logging level
you set. This is not the case for other INFO messages.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Enable SNMP trap logging:
snmplog enable
3. (Optional) Disable SNMP trap logging:
no snmplog enable
4. View the contents of the SNMP log:
show logging file module snmplog
Example
Enable SNMP trap logging and view the contents of the SNMP log:
Switch:1>enable
Switch:1#configure terminal
Switch:1(config)#snmplog enable
Switch:1(config-app)#show logging file module snmp
Enabling SNMP trap logging
December 2015 Managing Faults on Avaya VSP 7200 Series and 8000 Series 79
Comments on this document? [e-mail]