Managing Faults on Virtual Services Platform 7200 Series and 8000 Series Version 5

Name Description
Id Specifies the ID for the syslog host. The range is 1–10.
AddressType Specifies if the address is an IPv4 or IPv6 address.
Address Specifies the IP address of the syslog host. You can log system
log messages to external system log hosts with both IPv4 and
IPv6 addresses.
UdpPort Specifies the UDP port to use to send messages to the syslog
host (514–530). The default is 514.
Enable Enables or disables the sending of messages to the syslog host.
The default is disabled.
HostFacility Specifies the syslog host facility used to identify messages (local0
to local7). The default is local7.
Severity Specifies the message severity for which syslog messages are
sent. The default is info|warning|error|fatal.
MapInfoSeverity Specifies the syslog severity to use for INFO messages. The
default is info.
MapWarningSeverity Specifies the syslog severity to use for WARNING messages. The
default is warning.
MapErrorSeverity Specifies the syslog severity to use for ERROR messages. The
default is error.
MapFatalSeverity Specifies the syslog severity to use for FATAL messages. The
default is emergency.
MapMfgSeverity Specifies the syslog severity to use for Accelar manufacturing
messages. The default is notice.
Log configuration using EDM
December 2015 Managing Faults on Avaya VSP 7200 Series and 8000 Series 74
Comments on this document? [e-mail]