Managing Faults on Virtual Services Platform 7200 Series and 8000 Series Version 5

Chapter 12: Log configuration using EDM
Use log files and messages to perform diagnostic and fault management functions. This section
provides procedures to configure and use the logging system in Enterprise Device Manager (EDM).
Configuring the system log
About this task
Configure the system log to track all user activity on the device. The system log can send messages
of up to ten syslog hosts.
Procedure
1. In the navigation tree, expand the following folders: Configuration > Edit > Diagnostics.
2. Click System Log.
3. In the System Log tab, select Enable.
4. Configure the maximum number of syslog hosts.
5. Configure the IP header type for the syslog packet.
6. Click Apply.
System Log field descriptions
Use the data in the following table to use the System Log tab.
Name
Description
Enable Enables or disables the syslog feature. If you select this variable,
this feature sends a message to a server on a network that is
configured to receive and store diagnostic messages from this
device. You can configure the type of messages sent. The default
is enabled.
MaxHosts Specifies the maximum number of remote hosts considered active
and can receive messages from the syslog service. The range is
0–10 and the default is 5.
Table continues…
December 2015 Managing Faults on Avaya VSP 7200 Series and 8000 Series 72
Comments on this document? [e-mail]