Managing Faults on Virtual Services Platform 7200 Series and 8000 Series Version 5

Variable Value
• If the value is circuitless-ip, then for all syslog messages
(in-band or out-of-band), the circuitless IP address is used
in the IP header. If you configure multiple circuitless IPs,
the first circuitless IP configured is used.
max-hosts <1-10> Specifies the maximum number of syslog hosts supported,
from 1–10. The default is 5.
Use the data in the following table to use the syslog host command.
Variable Value
1–10 Creates and configures a host instance. Use the no operator
before this parameter, no syslog host to delete a host
instance.
address WORD <0–46> Configures a host location for the syslog host. WORD <0–
46> is the IPv4 or IPv6 address of the UNIX system syslog
host in the format A.B.C.D or x:x:x:x:x:x:x:x. You can log
system log messages to external system log hosts with both
IPv4 and IPv6 addresses with no difference in functionality
or configuration using ACLI..
enable Enables the syslog host. Use the no operator before this
parameter, no syslog host enable to disable syslog host. The
default is disabled.
facility {local0|local1|local2|local3|local4|
local5|local6|local7}
Specifies the UNIX facility in messages to the syslog host.
{local0|local1|local2|local3|local4|local5|local6|local7} is the
UNIX system syslog host facility. The default is local7.
maperror {emergency|alert|critical|error|
warning|notice|info|debug}
Specifies the syslog severity to use for error messages. The
default is error.
mapfatal {emergency|alert|critical|error|
warning|notice|info|debug}
Specifies the syslog severity to use for fatal messages. The
default is emergency.
mapinfo {emergency|alert|critical|error|
warning|notice|info|debug}
Specifies the syslog severity level to use for information
messages. The default is info.
mapwarning {emergency|alert|critical|error|
warning|notice|info|debug}
Specifies the syslog severity to use for warning messages.
The default is warning.
severity <info|warning|error|fatal> Specifies the severity levels for which to send syslog
messages. The default is info.
udp-port <514-530> Specifies the User Datagram Protocol port number on which
to send syslog messages to the syslog host. This value is
the UNIX system syslog host port number from 514–530.
The default is 514.
Configuring a UNIX system log and syslog host
December 2015 Managing Faults on Avaya VSP 7200 Series and 8000 Series 61
Comments on this document? [e-mail]