Managing Faults on Virtual Services Platform 7200 Series and 8000 Series Version 5
Table Of Contents
- Contents
- Chapter 1: Introduction
- Chapter 2: New in this document
- Chapter 3: Fault management fundamentals
- Chapter 4: Key Health Indicators using ACLI
- Chapter 5: Key Health Indicators using EDM
- Chapter 6: Link state change control using ACLI
- Chapter 7: Link state change control using EDM
- Chapter 8: RMON configuration using ACLI
- Chapter 9: RMON configuration using EDM
- Enabling RMON globally
- Enabling RMON on a port or VLAN
- Viewing the protocol directory
- Viewing the data source for protocol distribution statistics
- Viewing protocol distribution statistics
- Viewing the host interfaces enabled for monitoring
- Viewing address mappings
- Viewing the data source for host statistics
- Viewing network host statistics
- Viewing application host statistics
- Chapter 10: Log and trap fundamentals
- Chapter 11: Log configuration using ACLI
- Chapter 12: Log configuration using EDM
- Chapter 13: SNMP trap configuration using ACLI
- Chapter 14: SNMP trap configuration using EDM
- Glossary
================================================================================
Address Map Control Table
================================================================================
IDX DATASOURCE DROPFRAMES OWNER
--------------------------------------------------------------------------------
1 0.0.0.0 0 VSP
================================================================================
Host Control Table
================================================================================
IDX DATASOURCE NHDROPFRAMES AHDROPFRAMES OWNER
--------------------------------------------------------------------------------
1 0.0.0.0 0 0 VSP
Job aid
The following table describes the fields in the output for the show rmon ctl-tabl command.
Parameter Description
ADDRMAPCFG Describes and configures the probe support for the network layer and
application layer host tables for this protocol. The values can be one of the
following:
• NOT SUPPORTED
• SUPPORTED OFF
• SUPPORTED ON
If the value is SUPPORTED ON, the probe adds entries to the address map
table that maps the network layer address to the MAC layer address.
AHDROPFRAMES Shows the total number of application layer host frames that the probe
receives and drops. This value does not include packets that were not
counted because they had MAC-layer errors.
CREATETIME Shows when the entry was last activated.
DATASOURCE Shows the source of data for the entry.
DROPFRAMES Shows the total number of frames that the probe receives and drops. This
value does not include packets that were not counted because they had
MAC-layer errors.
HOSTCFG Describes and configures the probe support for the network layer and
application layer host tables for this protocol. The values can be one of the
following:
• NOT SUPPORTED
• SUPPORTED OFF
• SUPPORTED ON
If the value is SUPPORTED ON, the probe adds entries to the Host Control
table to collect statistics for network layer and application layer hosts.
IDX Shows a unique identifier for the entry in the table.
Table continues…
Displaying RMON information
December 2015 Managing Faults on Avaya VSP 7200 Series and 8000 Series 37
Comments on this document? infodev@avaya.com










