Managing Faults on Virtual Services Platform 7200 Series and 8000 Series Version 5
Table Of Contents
- Contents
- Chapter 1: Introduction
- Chapter 2: New in this document
- Chapter 3: Fault management fundamentals
- Chapter 4: Key Health Indicators using ACLI
- Chapter 5: Key Health Indicators using EDM
- Chapter 6: Link state change control using ACLI
- Chapter 7: Link state change control using EDM
- Chapter 8: RMON configuration using ACLI
- Chapter 9: RMON configuration using EDM
- Enabling RMON globally
- Enabling RMON on a port or VLAN
- Viewing the protocol directory
- Viewing the data source for protocol distribution statistics
- Viewing protocol distribution statistics
- Viewing the host interfaces enabled for monitoring
- Viewing address mappings
- Viewing the data source for host statistics
- Viewing network host statistics
- Viewing application host statistics
- Chapter 10: Log and trap fundamentals
- Chapter 11: Log configuration using ACLI
- Chapter 12: Log configuration using EDM
- Chapter 13: SNMP trap configuration using ACLI
- Chapter 14: SNMP trap configuration using EDM
- Glossary
Parameter Description
so a single, fragmented network-layer packet can increment the counter
several times.
INOCT Shows the number of octets transmitted to this address, excluding octets in
packets that contained errors. This value counts octets in the entire packet
that contained the protocol, not just the particular protocol frames.
OUTOCT Shows the number of octets transmitted by this address, excluding octets in
packets that contained errors. This value counts octets in the entire packet
that contained the protocol, not just the particular protocol frames.
CREATETIME Shows when the entry was last activated.
Displaying RMON control tables
View RMON control tables to see the data source for both network layer and application layer host
statistics.
Procedure
View RMON control tables:
show rmon ctl-table
Example
Switch: show rmon ctl-table
================================================================================
Rmon Control Table
================================================================================
================================================================================
Protocol Directory Table
================================================================================
IDX PROTOCOL ADDRMAPCFG HOSTCFG MATRIXCFG OWNER
--------------------------------------------------------------------------------
1 IP SUPPORTED SUPPORTED NOT SUPPORTED VSP
2 TCP SUPPORTED SUPPORTED NOT SUPPORTED VSP
3 UDP SUPPORTED SUPPORTED NOT SUPPORTED VSP
4 FTP SUPPORTED SUPPORTED NOT SUPPORTED VSP
5 SSH SUPPORTED SUPPORTED NOT SUPPORTED VSP
6 TELNET SUPPORTED SUPPORTED NOT SUPPORTED VSP
7 HTTP SUPPORTED SUPPORTED NOT SUPPORTED VSP
8 RLOGIN SUPPORTED SUPPORTED NOT SUPPORTED VSP
9 TFTP SUPPORTED SUPPORTED NOT SUPPORTED VSP
10 SNMP SUPPORTED SUPPORTED NOT SUPPORTED VSP
11 HTTPS SUPPORTED SUPPORTED NOT SUPPORTED VSP
================================================================================
Protocol Distribution Control Table
================================================================================
IDX DATASOURCE DROPFRAMES CREATETIME OWNER
--------------------------------------------------------------------------------
1 0.0.0.0 0 09/22/15 19:29:13 VSP
RMON configuration using ACLI
December 2015 Managing Faults on Avaya VSP 7200 Series and 8000 Series 36
Comments on this document? infodev@avaya.com










