Managing Faults on Virtual Services Platform 7200 Series and 8000 Series Version 5.1.2

Configuring SNMP interfaces
Configure an interface to send SNMP traps. If the switch has multiple interfaces, configure the IP
interface from which the SNMP traps originate.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Configure the destination and source IP addresses for SNMP traps:
snmp-server sender-ip {A.B.C.D} {A.B.C.D}
3. If required, send the source address (sender IP) as the sender network in the notification
message:
snmp-server force-trap-sender enable
4. If required, force the SNMP and IP sender flag to use the same value:
snmp-server force-iphdr-sender enable
Example
Switch(config)# snmp-server sender-ip 172.16.120.2 172.16.120.5
Switch(config)# no snmp-server force-iphdr-sender enable
Variable definitions
Use the data in the following table to use the snmp-server command.
Table 16: Variable definitions
Variable Value
agent-conformance enable Enables the agent conformance mode. Conforms to MIB
standards if disabled. If you activate this option, feature
configuration is stricter and error handling less informative.
Avaya recommends that you do not activate this option; it is not
a normally supported mode of operation.
authentication-trap enable Activates the generation of authentication traps.
force-iphdr-sender enable Automatically configures the SNMP and IP sender to the same
value. The default is disabled.
force-trap-sender enable Sends the configured source address (sender IP) as the sender
network in the notification message.
Table continues…
SNMP trap configuration using ACLI
January 2017 Managing Faults on Avaya VSP 7200 Series and 8000 Series 62
Comments on this document? [e-mail]